• Prepare the resin and hardener mixture to a maximum of 100 grams. The product usage time will be shorter in mixtures with higher amounts and the mixture may become unusable.

• The working time of the mixture is 15 – 25 minutes. The prepared mixture should be used within the working time. Otherwise, the product will overheat and dry without mixing in the container.

• Volumetric measurements made with tools such as beaker, glass, syringe, etc. will cause incorrect mixing ratio. In order to adjust the mixture amount correctly, you must use sensitive scales.

• The product is especially designed as very high viscosity.

• To minimize the formation of bubbles and air bubbles, take care to make the casting slowly.

• You can use a hot air gun and / or torch to remove bubbles on the surface after casting.

• In order to reduce the formation of air bubbles and bubbles in applications, a vacuum machine must be used.

• The mixed resin should not be moved after it has started to gel. Otherwise, fluctuations in texture and surface may occur.

• The mixed resin takes place approximately 12-16 hours after the initial drying. After the first drying, the final hardening process begins and this hardening process continues for 7 days.

• Work at room temperature. Low temperature can cause late drying and misting, and high temperature may cause early drying, yellowing and burning.

• For any reason, do not mix any other material that does not fit into the system.

• Make sure that the equipment you use during the application is dry and clean.

• Do not forget to use safety equipment.

• Avoid contact with your skin. May have an allergic reaction.

• Store the product you do not use at a temperature of 10 and 30 degrees in a closed area away from direct sunlight.

• Do not keep the products openly.

• Do not leave the products obtained as a result of the mixture under direct sun.

• In-product yellowing may occur in the product waiting for a long time.