• The working time of the mixture is 150 – 180 minutes. The prepared mixture should be used within the working time. Otherwise, the product will overheat and dry without mixing in the container.

• Volumetric measurements made with tools such as beaker, glass, syringe, etc. will cause incorrect mixing ratio. In order to adjust the mixture amount correctly, you must use sensitive scales.

• In order to minimize the formation of bubbles and air bubbles, take care to make the casting slowly and from a single point.

• You can use a hot air gun and / or smooth to remove bubbles formed on the surface after casting.

• In order to reduce the formation of air bubbles and bubbles in applications, a vacuum machine must be used.

• Resin should not be moved after it has started to gel. Otherwise, fluctuations in texture and surface may occur.

• Resin can be removed from the mold after approximately 18 -24 hours. After the product is removed from the mold, it starts the final hardening process and this hardening process continues for 7 days.

• Work at room temperature. Low temperature can cause late drying and misting, and high temperature may cause early drying, yellowing and burning.

• Never heat the product during mixing and application.

• For any reason, do not mix any other material that does not fit into the system.

• Make sure that the equipment you use during the application is dry and clean.

• Do not forget to use safety equipment.

• Avoid contact with your skin. You may have an allergic reaction.

• Store the product you do not use at a temperature of 10 and 30 degrees  in a closed area away from direct sunlight.

• Do not keep the products openly.

• Do not leave the products obtained as a result of the mixture under direct sun.

• In-product yellowing may occur in the product while waiting for a long time.